|
|||||||||||||||||||
|
 |
| Aerogard |
| ClearMask AR |
| Lightgard |
| Application Tools |
| About our Kits |
| Testimonials |
| FAQ's |
| Warranty & Returns |
| Join Our Mailing List |
| Installation Videos |
| Dealer Application |
| Give Us Feedback |
Shopping Cart Summary |
||||||||||||||
|
||||||||||||||
Installation Tips for Aerogard ™Film Before installing our film please consult our more detailed written instructions and our Installation video included in all of our paint protection kits. |
Film Installation Steps There are a number of steps that are common to the installation of almost any component of an Aerogard™ Paint Protection Film Kit. This procedure assumes a clean and dry painted finish to start with. |
1. The first step is to separate the film and attached liner from the clear cap sheet. Aerogard Ultra does not have a cap sheet, skip this step if using Aerogard Ultra. |
 |
2. Spray the painted surfaces
where the film will go
with soap solution. |
 |
3. Remove the white liner from the film, and spray the exposed adhesive with soap solution. Aerogard Ultra will have a clear liner. |
 |
4. The film is then positioned
on the car and the top side is
sprayed with soap solution. |
 |
5. The next step is to spray
water-alcohol solution under
the film at the starting position, |
 |
6. Then squeegee the film
down at that start position
to tack it in place. |
 |
7. Spray the outside of the
film again with the soap solution. |
 |
8. Then squeegee the film
from the start position
upwards and outwards towards the edges, |
 |
9. Stretching the film with the
palm of the hand, as necessary to
fit the part to the car. |
 |
10. The final step is to seal
and dry the film edges with a
hard card wrapped in a paper towel. |
 |
All kits come with our detailed written and video instruction guide. |
|
| Special Noteworthy Items |
It Takes more than a squeegee !! Installation Tips •Work in a dust-free environment with little or no wind, and out of direct sunlight. •Make sure the painted surfaces to be covered are both clean and dry. •Use all the appropriate application tools as described in the ‘Tools’ section above. •Pre-mix the soap solution and the water-alcohol solution ahead of time. • Remember - Aerogard™ film is elastic and forgiving - you can lift and reposition it as needed, there is no reason to rush the installation. Please take the time to fill our our feedback form to let us know how we are doing. |